| LW-50 Optical Wiring System |
| This product has been discontinued. |
|
Specifications
|
Optical I/O * |
| Type | Multimode glass-fiber |
| Core Diameter | 62.5 μm |
| Connector | ST type |
| Transmission Distance | max. 3 km (between two points) |
| *) For single-mode support or connector type conversion, please contact Otari. |
|
A/D Module |
| Input Impedance | -62 dB to -21 dB: 2 kΩ, 2 kΩ (+48 V)
-20.5 dB to +12 dB: 10 kΩ, 5 kΩ (+48 V) |
| Amplifier Gain | 62 dB to -12 dBu |
| Max. Level (non-clipping) | +36 dBu |
| Sample Rate | 48 kHz, 44.1 kHz (with EXT SYNC) |
| A/D Conversion | 20-bit ΔΣ 64x Oversampling |
| Frequency Response | 10 Hz to 22 kHz |
| Equivalent Input Noise | Mic Input EIN: Less than -123 dBu (max. gain, 200Ω terminated) |
| Distortion | Less than 0.008% (1 kHz, peak) |
| Signal-to-Noise Ratio | Better than 102 dB (1 kHz, A-WTD) |
| Crosstalk | Better than 100 dB (1 kHz) |
| Connector | D-sub 9-pin, female (rear connection type). XLR-3-32 (front connection type |
|
D/A Module |
| Output Impedance | max. 5Ω |
| Ref. Level | +4 dBu (-20 dB from digital peak) |
| Max. Level (non-clipping) | +24 dBu (digital peak) |
| Sample Rate | 48 kHz, 44.1 kHz (with EXT SYNC) |
| D/A Conversion | 20-bit 8x Oversampling |
| Frequency Response | 10 Hz to 22 kHz |
| Distortion | Less than 0.008% (1 kHz, peak) |
| Signal-to-Noise Ratio | Better than 102 dB (1 kHz, A-WTD) |
| Crosstalk | Better than 100 dB (1 kHz) |
| Connector | D-sub 25-pin, female (rear connection type). XLR-3-31 (front connection type) |
|
AES/EBU IN Module |
| Format | IEC 958, EIAJ CP-340, AES/EBU, S/PDIF |
Digital Audio I/F
(with transformer) | Impedance: 110Ω
Connector: D-sub 25-pin, female (rear connection type). XLR-3-31 (front connection type) |
| Sample Rate Converter | Acceptable Frequency Range: 9 kHz to 64 kHz |
|
AES/EBU OUT Module |
| Format | IEC 958, EIAJ CP-340, AES/EBU |
Digital Audio I/F
(with transformer) | Impedance: 110Ω
Connector: D-sub 25-pin, female (rear connection type). XLR-3-32 (front connection type) |
|
INTERCOM Module |
| A/D Conversion | 16-bit ΔΣ ADC |
| D/A Conversion | 16-bit ΔΣ DAC |
| Sample Rate | 16 kHz, 14.7 kHz (with EXT SYNC) |
| Quantization | 14 bits |
| Max. Input/Output Level | 2.8 Vp-p |
| Ref. Input/Output Level | 280 mVp-p |
| Termination | Unbal.: 220Ω impedance
Bal.: 320Ω impedance |
| Electric Power | DC output (single channel): 100 mA, 2.4 W |
|
EXT SYNC Module |
| No. of Channels | 8 (input or output) |
| Video Sync | Format: NTSC, PAL, SECAM (±100 ppm)
Input Level: 0.3 to 4 Vp-p (75Ω)
Connector: BNC |
| Word Sync | Frequency: 48 kHz, 44.1 kHz (±100 ppm) |
| Frame Sync | Frequency: 24, 25, 29.97, 30 Hz (±100 ppm) |
| Format | Sync to rising edge of square wave |
| Electrical Specification | TTL level |
| Input Impedance | 75Ω (with termination switch) |
| Connector | BNC |
|
RS-422A Module |
| Signal Format | RS-422A (TIA/EIA-422-B) |
| Driver Output Mode | Differential |
| No. of Connectable Units | 1 driver, 10 receivers |
| Max. Cable Length | 1,200 m |
| Max. Transmission Rate | 100 kbps |
| Power Voltage | +5 V |
|
RS-232C Module |
| Signal Format | RS-232C (TIA/EIA-232-E) |
| Driver Output Mode | Single-end |
| No. of Connectable Units | 1 driver, 1 receiver |
| Max. Cable Length | NA (up to 2500 pF) |
| Max. Transmission Rate | 20 kbps |
| Power Supply Voltage | ±6 to ±15 V |
|
Miscellaneous |
| Electric Power | 100 to 240 VAC (±10%). Single phase 50/60 Hz |
| Power Consumption | 200 to 350 VA |
| Operating Environment | Temperature: -10 to 50°C, Relative Humidity: 20 to 80% |
| Weight | 20 kg (2-slot model)
20 kg (4-slot model)
25 kg (6-slot model)
30 kg (8-slot model)
14 kg (PSU) |
| Dimensions (W x H x D) | 482 x 177 x 400 mm (2-slot model)
482 x 265 x 400 mm (4-slot model)
482 x 354 x 400 mm (6-slot model)
482 x 442 x 400 mm (8-slot model)
482 x 132 x 400 mm (PSU) |
|
Specifications are subject to change without notice or obligation.
|
home