| DX-5050 2ch MO Disc Recorder |
| This product has been discontinued. |
|
Specifications
|
Audio I/O |
| Analog Audio I/O | Mode: 2 channels. Transformerless active balanced
Input Impedance: 10 kΩ
Output Impedance: max. 50Ω
Load Impedance: min. 600Ω
Ref. Input Level: +4 dBu SRL (-15 dB from digital full-scale)
Ref. Output Level: +4 dBu (-15 dB from digital full-scale)
Input Gain Selection: 0, 20, 40, 60 dB (switchable)
Output Level Adjustment: +10 to -10 dBu (on rear panel), 0/-20 dB switchable (internal)
Max. Input Level: +28 dBu
Max. Output Level: +26 dBu (bal.)
Input Connector: XL-31 type (female) x 2
Output Connector: XL-32 type (male) x 2 |
| Digital Audio I/O | AES/EBU: Transformer I/O, 16 bits
Input Impedance: 110Ω
Output Impedance: 110Ω
Input Connector: XL-31 type (female) x 1
Output Connector: XL-32 type (male) x 1
SPDIF: No. of I/O bits = 16
Connector: Coax (RCA jack) and optical |
| Monitor Output | Built-in Speaker: 8Ω, mono
Output Power: 1 W
Headphones: Stereo (front panel)
Load Impedance: min. 8Ω
Output Power: 20 mW (8Ω load)
Connector: φ6.3-mm stereo phone jack |
|
Electronics |
| A/D and D/A Conversion | 16 bits |
| Frequency Response | 20 Hz to 20 kHz±0.5 dB (Fs = 48/44.1 kHz)
20 Hz to 14.5 kHz±0.5 dB (Fs = 32 kHz) |
| Dynamic Range | Fs = 48/44.1 kHz
min. 90 dB (EIAJ. 1 kHz, -60 dB, “A” wtd)
min. 85 dB (head amp gain 60 dB)
Fs = 32 kHz
min. 85 dB (EIAJ. 1 kHz, -60 dB, “A” wtd)
min. 82 dB (head amp gain 60 dB) |
| Signal-to-Noise Ratio | Fs = 48/44.1 kHz, emph off
min. 87 dB (DIN audio filter)
min. 83 dB (DIN audio filter + head amp gain 60 dB)
min. 90 dB (IEC A filter)
min. 85 dB (IEC A filter + head amp gain 60 dB)
Fs = 32 kHz, emph off
min. 72 dB (DIN audio filter)
min. 82 dB (IEC A filter) |
| Distortion (THD) | Less than 0.01% (0 dB, 1 kHz)
Less than 0.05% (-15 dB, 1 kHz) |
| Crosstalk | min. 90 dB (1 kHz)
min. 80 dB (20 Hz to 20 kHz) |
| Phase Difference between Channels | Within 2° (20 kHz) |
| Resolution of Edit | Destructive editing (per cluster, 44.1 kHz Fs)
92 ms (640-MB disc)
46 ms (540-MB disc)
23 ms (230-MB disc) |
|
Interfaces |
| Parallel I/O | Otari standard remote control (also usable for instant playback remote controller)
Command Input: TTL level, active low
Tally Output: Open collector
Connector: 37-pin D-sub |
| Serial I/O | RS-232C (PC connection) or RS-422A (editor connection) switchable internally (also acts as a fader interface)
Protocol: Otari or Sony 9-pin protocol
Connector: 9-pin D-sub (female) |
| SCSI Interface | The built-in MO drive can be used as an external storage device from the connected personal computer.
Standard: SCSI-2
Connector: Amphenol half pitch 50-pin |
|
Physical & Miscellaneous |
| Power Voltage Range | 85 to 260 VAC |
| Operating Environment | Temperature: 5 to 35°C, Relative Humidity: 20 to 80% |
| Power Consumption | 50 W |
| Dimensions | 282 x 120 x 355 mm (W x H x D, excl. case foot) |
| Weight | 7 kg |
| Option | 1) Rack Mount Adapter (19", 3RU)
2) Input Sample Rate Converter
3) CB-127 Remote Controller
4) CB-171 Instant Playback Remote Controller
5) Carrying Handle |
|
NOTE: Audio input is selected from analog, AES/EBU, COAXIAL, and OPTICAL. Digital audio output format is selected from AES/EBU (professional) or SPDIF (consumer).
Microsoft and Windows are registered trademarks of Microsoft Corporation.
Specifications are subject to change without notice or obligation.
|
home